Couldn't confirm presence of Flash 8 or higher because JavaScript was disabled.
We highly recommend that you install Flash 8 or higher and that you enable JavaScript.
Get Flash ---
I really do have Flash installed.
What follows is a plain HTML version of the Quiz.
All the questions and answers in this quiz are found in Tom Henry's book, "Conduit Bending Workbook".
1. The "star" symbol on the bender head is the mark for a .
- [ ] 3-point saddle center bend
- [ ] 90  stub-up bend
- [ ] back to back bend
2. The "arrow" symbol on the bender head is the mark for a .
- [ ] 3-point saddle center bend
- [ ] 90  stub-up bend
- [ ] back to back bend
3. The "tear drop" symbol on the bender head is for a .
- [ ] back to back bend
- [ ] 90  stub-up bend
- [ ] 3-point saddle center bend
4. A 3/4" conduit has a minimum radius to center of conduit of .
- [ ] 4"
- [ ] 4 1/8"
- [ ] 4 1/2"
5. The suggested handle length for a 1" hand bender is .
6. The shrinkage amount for a 30  offset bend over a 4" obstruction would be .
7. The 90  gain for a 1" EMT in a stub-up bend of 12" would be .
8. The 90  gain for a 3/4" EMT in a stub-up bend of 8" would be .
- [ ] 3 1/4"
- [ ] 2 1/2"
- [ ] 2"
9. The take-up for a 1" EMT 90  bend is .
10. A decimal of .625 would be .
- [ ] 9/16"
- [ ] 1/2"
- [ ] 5/8"
Click on the "Finish" button below to review your results. Next, click on your browser's "back" button or "arrow" keys to return to Tom Henry's Code Electrical book selection, "Conduit Bending Workbook".